Insights & Updates

New water production for Gold Water Ethiopia will be delivered soon

By HZM 566 views



One of the most famous beverage brand in Ethiopia-Gold water purchased two production lines from HZM company before In order to expand the production capacity, because of the previous good cooperation and the stability of the equipment, Gold water chairman choose HZM again without hesitation.

This new water production line is 36,000BPH 600ml, also suitable for 20,000BPH 2L. HZM provide the latest technology with 50T/H RO water treatment system, 8cavity full servo blowing molding machine with changeable pitches technology, XGF72-72-18 water filling machine with high-speed filling valve, 38,000BPH hot glue labeling machine and high-speed PE film packaging machine.

Recently, the water production line test has been completed by HZM inspection department and Gold Water technology department also finished inspection test.

Thank very much for customer trust in HZM. HZM will insist on insist on innovation, bringing advanced technology, reliable products and timely service to our customers.

Talk to our engineering team

Need help planning your packaging line?

Share your product, bottle and capacity requirements for a practical equipment recommendation.

Equipment for your project

Continue reading

2026-09-04

RO Differential Pressure Keeps Rising: Fouling Location Matters

Locate the stage where pressure loss is increasing and relate it to normalized flow and salt passage. A first-stage rise often points to particulate or biological fouling; a later-stage rise can indicate scale, but feed analysis is required. Follow this practical fault-isolation, repair and prevention guide for bottling-line operators and maintenance teams.

Learn more

2026-09-02

Why Do Filling Valves Drip After the Bottle Leaves?

Dripping usually comes from contamination on the valve seat, worn or swollen seals, trapped pressure, incorrect closing timing or product viscosity outside the setup window. Identify whether the leak follows one valve or the entire filler. Follow this practical fault-isolation, repair and prevention guide for bottling-line operators and maintenance teams.

Learn more

2026-08-28

Sleeve Labels Wrinkle After the Shrink Tunnel

Determine whether the sleeve was straight before entering the tunnel. Then check film shrink curve, tunnel-zone temperature, airflow or steam distribution, bottle moisture, conveyor speed and container geometry. Follow this practical fault-isolation, repair and prevention guide for bottling-line operators and maintenance teams.

Learn more

2026-08-23

Bottle Rinser Has Low Spray Pressure: Causes and Repair Steps

Check whether the loss affects the entire rinser or only several nozzles. System-wide loss points to supply, pump, filter or valve problems; a local pattern points to blocked nozzles, damaged tubing or a misaligned bottle. Follow this practical fault-isolation, repair and prevention guide for bottling-line operators and maintenance teams.

Learn more

Build your production line

Talk with an HZM beverage packaging specialist

Tell us your beverage, container, capacity and target market. Our engineering team will prepare a practical line proposal.

WhatsApp Email Facebook